angle head

Process and method to solve the problem of retarded material in the extruder during production by way of improving taper angle of screw head, connector flange and structure of perforated plate are presented.

介绍了通过改进螺杆头锥角、连接件法兰以及多孔板结构以解决挤出机生产过程中滞料问题的办法。

Bit cutting angle spiral bevel milling cutter head sharpening machine

钻冠的尖度，钻头磨角，钎子头刃角螺旋锥齿轮铣刀盘刃磨床

Then, the BP neural network was employed for prediction of the relationship of lift head and efficiency-performance index with the flow rate, the angle of blade installation, etc.

以某轴流泵试验数据为样本，BP人工神经网络为工具，对轴流泵模型进行了泵扬程及效率性能指标与流量、叶片角度等相关因素间的性能预测研究。

Liquid forging processing to thin wall waveguide angle head has been experimentally studied.

本文对簿壁波导弯头件的液态模锻成形进行了研究。

If Angle sun valley, rate line has swelling, nodules, for less Yang blood winding block, appropriate diarrhea; Head d acupuncture point week has a swelling, nodules, Yang Ming blood for collaterals block, appropriate diarrhea.

若角孙、率谷线有肿胀、结节，为少阳血络阻滞，宜泻；头维穴周有肿胀、结节，为阳明血络阻滞，宜泻。

The second injection pump drive and installation, the secord injector arrangement, the cylinder head and rocker arm support modifications are described in detail, as well as the installation of crankshaft rotation angle grating disc which is necessity for combustion research in cylinder pressure sensor.

详细论述了喷油泵的安装和驱动、喷油器的布置、气缸盖和摇臂座的改造以及气缸压力传感器、曲轴转角信号光栅盘轴的安装。

The paper proves that the error caused by the operator when adjusting cutting head angle, blade angle and grinding system will have influence on cigarette rod cutting quality;

本文分析了在调整刀盘角度、切刀角度、磨削装置过程中，由于操作者所带来的误差（测量误差）对烟支切割质量的影响；

The FTE SAMs was characterized by the time-of-flight secondary ion mass spectrometer ( TOF-SIMS), atomic force microscopy ( AFM) and contact angle measurement, and the tribology properties of the FTE SAMs were measured by the Olympus head/ disk interface reliability measurement system.

应用时间飞行二次离子质谱仪（TOF-SIMS）、原子力显微镜（AFM）和接触角测量仪对FTE自组装膜进行表征。通过Olympus磁头磁盘界面可靠性测试系统对FTE自组装膜的摩擦学性能进行研究。

Test results show that the flow regime is good in a head tank with a greater length of the outlet pond and a smaller contract angle, while the sediment deposition is heavy.

试验结果表明，出水池长度较长，收缩角较小的高位井中的水流流态较好，但池内泥沙淤积程度较重。

During toothbrushing, bristles should be placed at an angle against the gum margins, gently move the toothbrush back and forth in small amplitude like massaging the gums with only the bristles moving but the toothbrush head hardly moves.

刷牙时，刷毛要斜斜的放在牙龈旁边。刷牙的动作幅度不要大，前前后后的，好像在摩擦牙齿，刷毛在摆动，但牙刷头只是少许摆动。